Hi,
I am integrating an I210-IT onto a breakout card and have run into a problem getting it up and running. we are using the I210 internal PHY in flash less mode.
- I first used the lanconfw64e tool to check the I210 was visible as a blank device
- I then used the EEUPDATEW64e tool to load the "I210_Invm_Copper_APM_v0.6.txt" image. The updater tool said this completed successfully.
- I used the lanconfW64e tool to re check the visibility of the device and it is now recognized as "Intel<R> I210 Gbit Network Connection". I also checked the registers which are now updated with new data.
- I then downloaded the Intel drivers from the Download center and installed. This said it completed successfully.
I now have a yellow triangle on the image in device manager and the following error "failed to initialize adapter (code 10)"
Re running the lanconfW64e tool i get the following message
And if i open the resource as suggested i get the following
Any help would be appreciated as a little lost on this one.
Kind Regards
Robert