Hello
I see on RVP7 CRB schematics, page 49, that CFG[4] signal is tied up to VCCIO.
However, Skylake EDS, Vol1 on page 49 (too:)) says that "eDP port is Disabled if No Connect Pull-Down resistor on CFG[4]"
Does it mean that eDP port won't work on RVP7 board?
Is it possible to correct this by software? I have Skylake-U COM board on my table now. It does not work with eDP port, probably because of this issue.
With best regards,
Nikolay